 |
 |  |  |  |
 |
 |  |
 |
Home obsolete products EM100FX-ST |
| EM100FX-ST |
The EM100 FX is the first Fast Ethernet PCI adapter to support the IEEE 100BASE-FX ideal for use in 'electrically noisy' environments such as building risers and factory floors, and also in backbone environments where longer cabling distances are required. For maximum throughput, EM100 FX includes Full Duplex Fast Ethernet (FDFE) capability, which doubles the cumulative system throughput rate in switched or dedicated backbone environments. FDFE capability is easily enabled via software configuration.
|
Note: Only drivers that are not included or embedded within a supported operating system are listed below. To see a complete list of supported operating systems see the Product Specifications Select your operating system or software below |
|
MicrosoftMicrosoft DOS Microsoft Windows 95 Microsoft Windows NT Novell NetWareNovell NetWare Downloads |
UnixSCO Unix SCO UnixWare |
|
|
|
|
|
Bus System Interface Type |
|
| PCI, 32-bit bus master | |
| Data Transfer Rate | |
| 100 Mbps | |
| System Requirements | |
| PCI local bus computers based on Intel, DEC Alpha, MIPS, and PowerPC processors | |
| Warranty | |
| Limited Lifetime Warranty | |
|
Interface Connections Supports 62.5/125 micron multimode fiber ST (twist-on) Ethernet Controller DECchip LAN coprocessor chip FIFO Buffer Memory 256 Byte transmit 256 Byte receive Hardware Interrupts PCI interrupt A, supports shared interrupts Base IO or Memory Address Assigned by BIOS Diagnostic LEDs Link Integrity Board Dimensions 5.075" x 3.9" (conforms to PCI Short Card specifications) Power Consumption +5V @0.5A max Operating Characteristics 32° to 122° F (0° to 50° C) |
