Adaptec
 
leftbar
leftbar
DuraStor 6200SR
The Adaptec DuraStor 6200SR RAID Appliance is a 1U enclosure with a single Adaptec DuraStor 6200S RAID Controller card. The appliance is upgradeable to dual controller cards for increased data protection in active-active mode. It features high-performance data through-put up to 160MBs per second and up to 15,000 IOPS with robust RAID level support and easy online-capacity-expansion (OCE). Its hot-swappable RAID controllers, power supplies, and cooling fans, provide extensive fault-tolerance guarding against any single point of failure.
Small Image of DuraStor 6200SR
DownloadsDocumentationTechnical Specifications

Note: Only drivers that are not included or embedded within a supported operating system are listed below. To see a complete list of supported operating systems see the Product Specifications

Select your operating system or software below

Bios Updates and Other Downloadable Files

Bios Updates and Other Downloads

Network or Host Interface
Ultra160 SCSI

Hot-Swap and Redundant Components

RAID controllers, power supplies, cooling fans, and AC power cords

Number of RAID Controllers

1 Ultra160 SCSI controller, (upgradable to 2 controllers)

SAF-TE Compliance

SAF-TE Compliant

On-Board CPU

Pentium II 333 MHz, 32 KBytes L1 cache, 256 KBytes L2 cache on-chip

Host/Device Data Burst Rate

Up to 160MBytes/sec

Number of Host Channels

One or two Ultra160 SCSI channel(s)

Number of Device Channels

Two or three LVD Ultra160 SCSI device channels

Compatible with LVD SCSI

Ultra2 SCSI and Ultra160 SCSI protocols

Advanced RAID Features

Host independent active-active failover and failback (November 2001)
Write-back data cache memory bus, 800 MBytes/sec bandwidth
On-line capacity expansion (OCE)
Spare pooling and dedicated spares; array verification
Controller/drive hot-swap supported
Array status monitoring; adjustable stripe size; automatic sector re-mapping
User-settable priority for array reconstruct, verify, create, and expand operations
Arrays can be configured for RAID levels 0, 1, 3, 4, 5, 10, 50, JBOD
Up to 24 independent logical arrays per subsystem

Advanced Hardware Features

128 MBytes expandable to 512 MBytes of PC 133 SDRAM
DIMM, 16 MBytes of ECC-protected SDRAM processor memory
Integrated Nickel Metal Hydride (NiMH) cache battery backup Flash upgradable firmware, 2 MByte
Stand-alone DuraStor 6200S RAID controller does not include memory and battery

Advanced SCSI Features

Ability to process 70 simultaneous commands
Tagged Command Queuing supported
Reserve/Release (multi-host ready, up to 15 initiators with single controller)
Up to 15 devices per channel (14 in active-active mode)
Domain validation and cyclical redundancy checking (CRC) data protection with Ultra160 SCSI drives

Input Voltage

100-240 VAC (auto-sensing)

Input Current

2.0/0.8 Amperes (maximum)

Input Frequency

50-60 Hz

Power Supply Rating

150 Watts

Power Source

Dual hot-swappable power supplies (power factor correcting)

Cooling Module

Cooling module with 3 redundant fans

Dimensions

H–1.70 inches W–17.70 inches D–24.50 inches

Weight

28 lbs with 2 controllers

---

rightbar
rightbar