Changing the Auto-Discovery Settings

Auto-discovery, in maxView Storage Manager, is enabled by default. The auto-discovery task runs in the background each time maxView Storage Manager is started. You can disable auto-discovery if desired, and configure the auto-discovery settings described below.

To change the auto-discovery settings on a system:

  1. In the Enterprise View, select a system.
  2. On the ribbon, in the System group, click System Settings.

    The maxView Storage Manager Agent Settings window opens for that system. The auto-discovery settings appear at the bottom:



  3. To enable/disable auto-discovery, select Enable Auto Discovery. (This option toggles between enabled and disabled.)
  4. Update the auto-discovery settings, as needed:
    • In the Auto Discovery Base Port field, enter the port number for the auto-discovery task. You can use any available port for auto-discovery. The default port is 34570. If you change the port, you must restart the maxView Storage Manager Agent for the change to take effect.
    • In the Auto Discovery Interval field, enter the number of seconds between each auto-discovery check. This number determines how often maxView Storage Manager checks for changes in remote system resources. The default is 360 seconds.
  5. Click OK to save the changes.

Email Address (optional):

Did this topic answer your question?

Strongly Agree
Agree
Neutral
Disagree
Strongly Disagree

Comments: