Update

Updates the flash components of one or more RAID controllers on your computer from the flash image data in a UFI file. You must restart the computer following an UPDATE command.

The command syntax for the UPDATE command is:

AFU UPDATE [/C<Controller ID>] [/D <UFI File Path>]
This example shows a typical system response after an update.
A:\> AFU UPDATE /C 0 
Adaptec Flash Utility V4.0-0 B5749 
(c)Adaptec Inc. 1999–2005. All Rights Reserved. 
Updating Controller 0 (Adaptec RAID 31205) 
Reading flash image file (Build 5749) 
AFU is about to update firmware on controllers Adaptec RAID 51645 
***PLEASE DO NOT REBOOT THE SYSTEM DURING THE UPDATE*** 
This might take a few minutes. 
Writing Adaptec RAID 51645 (4MB) Flash Image to controller 0...OK. 
Verifying...OK 
Please restart the computer to allow firmware changes to take effect.

Email Address (optional):

Did this topic answer your question?

Strongly Agree
Agree
Neutral
Disagree
Strongly Disagree

Comments: