Setting the Boot Controller

Note: If your system won’t contain more than one bootable controller, skip to the next section, Creating an Array.

Your Adaptec RAID controller supports bootable disk drives and bootable arrays. To enable your system to boot from either a disk drive or an array connected to your controller:

  1. Enter the system setup.
  2. Navigate to the drive boot sequence.
  3. Move the boot controller to the top of the list.
For more information, refer to your computer documentation.

Email Address (optional):

Did this topic answer your question?

Strongly Agree
Agree
Neutral
Disagree
Strongly Disagree

Comments: