Procedure for adding a AHA-1540/1542 to a pre-existing installation of 0S/2 version 1.3
This installation procedure assumes the following:
- The user has previously correctly installed 0S/2 v 1.3 on a system
- Original installation did not include any Adaptec Host Adapter
(e.g. installed on an IDE disk)
- The system currently boots and runs properly
- The user now wishes to add an Adaptee AHA-1540/1542 and SCSI disk drive(s)
to the system
- The user does not wish to re-install OS/2 v 1.3 from scratch
(i.e. does not want to start over)
- The user has the original OS/2 v 1.3 boot diskette
- The user has the Adaptee ASW-1220/1420 v 1.3 diskette
If the above statements are all true, then please proceed as follows:
- Boot the system and get to an OS/2 prompt
- Boot the system to the 0S/2 v 1.3 install diskette
- Press <Esc> to get an OS/2 prompt
- Save a complete copy of all the files in the root directory of disk drive C:
into a temporary subdirectory. This is so that you can get back to where
you started should you choose to do so.
- From the root directory type
MD SAVE
- Now type
COPY C:\*.* C:\SAVE
- Insert the ASW-1220/1420 v 1.3 diskette into the A: (or B:) floppy drive.
- Copy all the files from A:\DISK0, A:\DISK0\1540, and A:\DISK0\SHARE to
the root directory of C: as follows:
COPY A:\DISKO\*.* C:\
COPY A:\DISK0\1540\*.* C:\
COPY A:\DISKO\SHARE\*.* C:\
This step will overwrite some of the system files. The original files are in C:\SAVE
"Down" the system, turn off the power, and install the AHA-1540/1542 board
into your system. Although the default jumper setting on the board is
correct for most systems, please adjust the jumpers as required to avoid
any possible Interrupt, DMA or Port Address conflicts. Refer to the
Installation Guide.
Reboot the system. The system should boot and automatically load
the necessary LADDR drivers to support the AHA-1540/1542 board.
No changes to the CONFIG.SYS file are necessary for disk.
Notes:
This same procedure can also be used to install the AHA-1740, AHA-1640
or AHA-1520/1522 boards.In the fourth step, be sure to copy the files for your board type
to the root directory on C: For example: For the AHA-1520\1522, type:
COPY A:\DISK0\1520\*.* C:\
For the addition of peripherals other than disk (e.g. CD-ROM), changes
to the CONFIG.SYS file may also be required.
|
|