To customize any other parameters for the Windows 95 driver, from the Network dialog box within the Control Panel, highlight the Adaptec PCI adapter, choose "Properties," and then choose "Advanced."
Special Notes:
Full Duplex Operation: Change the Connection Type to one of the Full Duplex options.
All custom parameters are described below.
Connection Type
This parameter determines the type of cable to be used with the Adaptec adapter.
Autodetect Default Connection
Detects the cable type and ptimal line speed for the specific Adaptec PCI adapter model in use. This is the default and recommended connection type to select.
INITSENSE/Half Duplex
Autosenses line speed and cable type at adapter initialization time only
INITSENSE/Full Duplex
Autosenses line speed and cable type at adapter initialization time only, with FDE activated
100 Mbps
Sets speed to 100 Mbps manually (10/100 models only)
100 Mbps/Full Duplex
Sets speed to 100 Mbps manually with FDE activated (100 TX and 10/100 TX models only)
10 Mbps/UTP
Sets speed to 10 Mbps UTP manually (10 and 10/100 models only)
10 Mbps/Full Duplex
Sets speed to 10 Mbps UTP manually with FDE activated (10 and 10/100 models with RJ-45 port only)
THIN
Sets cable type to BNC Thinnet manually (Combo and BNC models only)
ACTIVESENSE/Half Duplex
Autosenses line speed and cable type at adapter initialization time and during runtime. For use only when a cable is attached to adapter
ACTIVESENSE/Full Duplex
Autosenses line speed and cable type at adapter initialization time and during runtime, with FDE enabled. For use only when a cable is attached to adapter
Bus Number
This parameter specifies the PCI Bus # on which the Adaptec PCI adapter resides.
Default: 0
Range: 0, 1, 2
|