Adaptec
 
leftbar
leftbar
AHA-F950
Support for the AHA-F940/AHA-F950 Fibre Channel products is now provided by Jaycor Network Inc., at www.jni.com or by emailing your request to support@jni.com.
Small Image of AHA-F950
DownloadsDocumentationTechnical Specifications
No drivers are currently available for this product from Adaptec.
There are a few possible reasons for this:

- The product is supported by embedded drivers that are available in the supported operating systems.

- The product is supported by drivers that are embedded in the product.

- The product was recently introduced and there are no new drivers available.
Product Documentation
Install Guide for the AHA-F940/F950 (PDF 90 KB)

Bus System Interface Type

64-bit PCI-to-Fibre Channel
Data Transfer Rate
267 MByte/sec

PCI Features

64-bit PCI data path
64-bit PCI addressing
Zero-wait-state PCI bus master transfers with cache line streaming
Independent PCI DMA channels for data and commands

Multitasking RISC protocol engine (MTPE) features

Management of Fibre Channel link, PCI bus, and command channel operations to reduce overhead and latency
Downloadable microcode for simplified updates
Diagnostic execution for subsystem Built-in-Self-Test (BIST)

Memory Subsystem Features

Local SRAM command queue for up to 1500 commands
Local BIOS ROM and SEEPROM supports Int 13 BIOS,
Open Firmware, and PCI configuration
Parity protected data paths

Software Support

Support for industry-standard operating systems
including Windows NT, MacOS, NetWare, UnixWare, Solaris and I20
Control utility for storage management
Int13 BIOS for storage-based system boot for Intel based systems
Open Firmware support for storage-based system boot for UltraSPARC and compatible systems
Operating system porting, driver and BIOS development kits

Package Contents

AHA-F950 PCI-to-Fibre Channel Host Adapter
Drivers for Windows NT, MacOS, NetWare, UnixWare, Solaris, and I2O
Control utility for easy Fibre Channel storage management

---