Computers equipped with PCI buses should automatically detect and configure PCI-compliant adapters, preventing you from having to manually add the network adapter.

After putting the network adapter in the computer, start Windows 95.

1. The "New Hardware Found" dialog box appears. Select Driver from disk provided by hardware manufacturer.
   

   Note: If the "New Hardware Found" dialog box doesn't appear, you'll need to configure the adapter using the "Add New Hardware" wizard in the Windows 95 Control Panel.

2. Insert the Adaptec ALANE Drivers for Windows 95 disk in a floppy drive and click OK. Windows 95 will copy the driver files to your computer.

3. Restart your computer when prompted by Windows 95.

If installation failed...
Some PCI computers may require manual driver installation, follow the steps below:

1. Click Start icon.
2. Select Settings/Control Panel.
3. Select Network icon.
4. Select ADD.
5. Double click on Adapter.
6. Select "Have Disk".
7. Insert the Adaptec ALANE Drivers for Windows 95 Diskette into your floppy drive.
8. Specify the drive letter of the diskette drive that contains the ATM software, then select OK.
9. Select "Adaptec LANE Adapter - ANA-59x0 (ELAN1)" for installation of the first ELAN.
10. Select OK in Network Box.
11. Select Restart.

Adapter Configuration:

1. Click the Start icon.
2. Select Settings/Control Panel.
3. Select Network.
4. Double click "Adaptec LANE Adapter..." in the "Network" window.
5. Select Advanced. All of the available parameters for the adapter can be set via this configuration screen. When you have made all of the required changes, save the changes, and restart the computer to allow them to take effect.

Removing drivers:

1. Click the Start icon.
2. Select Settings/Control Panel.
3. Select Network.
4. Select "Adaptec LANE Adapter..."
5. Select Remove.
6. Select OK in the "Network" box.
7. Restart the computer to complete the removal.

Advanced options:

Elan Name

This field is optional. Specify a character string if the switch supports this feature.

LAN Type

This should be "802.3" if Ethernet Emulation is to be enabled in the LANE driver.

MTU Size

This should be "9234" or "1516". Note: When choosing 9234, make sure the LES/BUS supports it.

Peak Cell Rate

The valid values are 0-353208 (155 Mbits). The value 0 default to full line rate of the the NIC. Note: for 25 Mbits use PCR value of 58962.

Port Index

Default value is 0 (only one adapter is supported currently).

Server Address

Address of the LECS or LES. Should be a 20 byte (hex) address separated by dots(.). The default value is the ATM Forum WELL KNOWN Address.

Server Type

This should be "lecs" if the server is a configuration server or "les" if the server is the LAN Emulation Server.

UNI Version

3.0 is default